Most Florida homes are cooled by an AC that's too big for them. It drops the temperature but doesn't run long enough to pull humidity out, which is why the house still feels sticky at 74°. We do the load math right, match the equipment to the home, and install it to last.
Bigger isn't better. A 4-ton unit in a home that needs 3 tons will cool fast and shut off fast, cycling on and off without running long enough to dehumidify. You end up with a house that's 72° and 60% humidity. Cold, but clammy. The compressor also wears out faster from the short-cycling. We see it constantly: homeowners who paid for the "upgrade" and got a worse-performing system. Proper installation starts with proper sizing.
Before we quote equipment, we measure your home room by room: square footage, ceiling height, insulation R-values, window area and orientation, shading, air infiltration, occupancy, heat-generating appliances. We run an industry-standard load calculation (the ACCA Manual J method) on those numbers to tell us the exact BTU load your home needs to be comfortable. Then we spec equipment to match. Not round up. Not guess from the old unit's nameplate. Right inputs, right math, right equipment.
A properly sized system runs longer cycles at lower load. That sounds counterintuitive, but longer runs are how you actually remove humidity. The coil stays cold enough, long enough, for water to condense and drain away. Your home feels comfortable at 76° instead of uncomfortable at 72°. You use less electricity because you're not constantly starting the compressor. The equipment lasts years longer. Everyone wins, except the contractor who wants to sell you the biggest box.
Every family's situation is different, how long you plan to stay, how hot your house gets, whether you want smart features, whether monthly FPL cost matters more than upfront cost. We walk you through all three tiers at quote time and let you choose. Here's the shape of it.
Single-stage. Federal minimum efficiency. Proven reliable platforms from Goodman, Rheem Classic, Carrier Comfort. The right pick for rentals, flips, or homeowners on a tight budget. 10-year parts warranty.
Two-stage. The sweet spot for most Florida homes. Runs on low stage most of the time, quieter, gentler on the compressor, noticeably better humidity control. Typical payback: 4–6 years.
Variable-speed inverter. Carrier Infinity, Trane XV, Lennox SL. Modulates output continuously, whisper quiet, best-in-class humidity, lowest bills. Best choice if you're staying in the home 10+ years.
For homes that want both heating and cooling from a single unit. More efficient than a strip-heat air handler in Florida's mild winters. Modest equipment upcharge that often pays back on winter electric bills alone.
Florida HVAC quotes are notorious for leaving out the parts that matter, then adding them to the bill on install day. Here's everything that's in ours by default, with no surprise charges.
Outdoor unit, new pad, hurricane tie-downs to Florida code, proper refrigerant line-set isolation, and a factory-level refrigerant charge (weighed, not guessed).
Matched indoor unit, ECM blower motor, replacement of primary and secondary condensate lines, new float safety switch, and a properly-sized filter slot.
We pull the permit in your name, coordinate with the county inspector, and don't leave until it's signed off. Some competitors skip this and the homeowner pays in resale later.
Ecobee or Honeywell T6 included. Full commissioning: refrigerant pressures verified, static pressure measured, airflow balanced, temperature split confirmed, all documented in writing.
We come out, measure the home, run the numbers, and give you a fixed written quote. Usually within 48 hours of your call. No obligation.
Most installs move from "first call" to "up and running" in five to seven days. Here's exactly how that unfolds.
We visit, measure, run Manual J, test duct static pressure. About 60–75 minutes. No charge.
Three tiers priced, equipment specs, warranty terms, financing pre-approval if you want it.
Permit pulled in 1–2 business days. Install typically scheduled within the same week.
Crew arrives 8am, old system out, new system in, commissioned, cooling by evening.
County inspection within a week. We walk you through the thermostat, filter schedule, and warranty registration.
A new system is a real investment, and for most families it's unexpected. We partner with Synchrony and Wells Fargo to offer 0% for 18 months (on approved credit), 60-month and 84-month fixed-rate plans, and reduced-rate programs for high-efficiency systems that qualify for energy-efficiency financing. Pre-qualification takes about two minutes and uses a soft credit pull.
Ask about FPL rebates too, Florida Power & Light runs a residential HVAC rebate program for qualifying high-efficiency systems that can offset a meaningful portion of the upfront cost. We handle the paperwork.
Every new system we install is registered with the manufacturer on your behalf, because unregistered warranties default to 5 years, and we've seen that cost homeowners thousands down the road. You get the full 10-year parts coverage on compressor and major components.
Our own labor warranty covers 2 years on the install work. Champions Club members get that extended for the life of their membership, plus priority scheduling, two annual tune-ups included, and a 15% discount on any future repair parts.
We come out, measure your home, run the load calc, and hand you a fixed written quote. Typically within 48 hours of your call.
We'll call you within 30 minutes. For immediate needs, call (561) 503-3003.
